HOW TO INSTALL THE CHIPWERKE PIGGYBACK TUNER

The ChipWerke piggyback tuning module connects to several engine sensors on your vehicle, tapping into the factory wiring harness with OEM-quality plugs. No wire splicing, cutting, drilling, or permanent modifications are required. The instruction guide included in your package shows the exact connection points and mounting steps for your specific vehicle. While the exact sensor locations vary by application, the basics below apply across every install.

* The vehicle shown in the guide may look different from yours, but it uses the same engine.

BEFORE YOU START

  • Turn off the engine and let it cool down.

  • Leave the driver's door open for 15 minutes while keeping the key fob at least 35 feet away from the car. This ensures the ECU fully powers down before you disconnect anything.

  • Have your vehicle-specific install guide (included in the package) on hand, since connection points differ from engine to engine.

INSTALLATION STEPS

  1. Locate your mounting spot.Choose a place for the module away from areas that run hot, such as near the exhaust manifold or turbo housing.

  2. Connect the harness.Plug the ChipWerke connectors inline with the factory sensor harness as shown in your vehicle-specific guide. Every plug should seat securely; there should be no unused or loose connectors when you're done.

  3. Route and secure the wiring.Make sure the harness isn't stretched tight anywhere and is routed away from moving parts, sharp edges, or excessive heat.

  4. Protect against water.Keep connections and wiring clear of areas exposed to standing water or heavy spray.

  5. Mount the module.Secure it firmly to your chosen spot so it won't shift or vibrate loose while driving.

  6. Double-check everything.Confirm all plugs are fully seated, wiring is tidy and protected, and the module is mounted securely before starting the engine.

Important Note

You must follow these instructions properly to avoid receiving a check engine light or other issues. Also, ensure you hear a 'click' sound when connecting the plugs, as this signifies a secure connection.

AFTER INSTALLATION

Once everything is connected and secured, start the vehicle as normal. No reflashing, relearning, or additional setup is needed for the module to work.

You can always contact us for troubleshooting or further support.